Fiat Dino Forum (FDF)

Hello all,
I am restoring a 2000 Spider and have a question about installing seat belts.
I saw on dinoitalia this page showing seat belts
http://www.dinoitalia.com/tecnica_cintu ... rezza.html
I would like to install 3points in front and lap belts in the rear. Any ideas about anchor locations and where to find seat belts?
The sticking point is the front shoulder belt - where to anchor???
One option might be Dinoparts lap belts and 246GT 3 point belts??
Does anyone have any experience or advice on this?
thanks!

As far as I know there were never 3-Points in a 2000 Spider

Hi thanks. I know they did not have them but I guess I would like to know how to do it (seeing that the 2400 had them)

See Quik fit in the uk. We had reinforced mounts fitted behind the seats ( think they may have been from a mondeo) and the inertia reels are in the map pockets.

Thanks for this information. i will contact quick fit. Would you happen to have a picture of the placement of the inertia reels in the map pockets or indeed the whole set up? Kind regards

You can see here how they are installed in a Coupe:
http://fiatdinoforum.org/viewtopic.php? ... belt#p2062