Fiat Dino Forum (FDF)

The question was why ? There are 2 hosens, one in the front and one on the last intake of the carburetors. The middel one has a small short circuit between the 2 barrels - I am guessing it does the same as the hose. But I dont undestand the purpose either ?

Yes, let me know you email and I will send you some more information.
Regards

Hi All
A friend of mine is looking to sell his spider project. Any interest PM me. The car is located in Denmark, close to Copenhagen.

Sure, just send me a PM and what you need to know. You will (most probably) not finde a more original car.

Hi I am located in Denmark. I have an 67 Spider no 179 and an 68 2L coupe.
Regards Jesper

In the firewall (seen from the engine bay) - just behind the gas throttle there is a 6mm hole, that is for the hand-throttle. If you look 10cm towards the middle of the car there is another 6mm hole (you need to remove the air filter box to see it) - this is for the choke cable. But if it the routin...

Do you have this :

You should check Mike Morris book : March 1967. Italian registration details show that 17 cars were registered in March 1967, 39 in April, 96 in May, 90 in June, 60 in July, 39 in August, 16 in September, 12 in October, 8 in November, 6 in December then 44 in January 1968, 35 in February and 42 in M...

Hi
It very easy, the CB box just needs 12V and ground and the it takes the signal from the optical sensor. The Bosch unit will the see the "advanced" signal from the CB box. The attached diagram was just made for my own use, please bare with me on the pure layout.

Hi I did something similar, but I just hooked the below box before the Bosch setup from Adrian. The box only controls the advance and the Bosch module still gives the spark. Works perfekt and it makes a big difference to change the advance. I have full advance already around 3000 RPM, it makes the e...