Fiat Dino Forum (FDF)

Hi,
Thanks for your reply, Dario! It sounds like a removal of the dash is almost necessary to be able to do this job. If I do I’ll be sure to post photos and info.
Kind regards,
Anders

Hi all, I'm thinking of removing and cleaning all of the gauges on my 2400 coupe. I'd like to clean the inside of the glass on each gauge, since they have become a bit dusty over the years. Has anyone done this? What is the best/correct way to remove the glass? Any advice on this topic would be grea...

Hi,
Thanks for the advice! I'll give that a try.
Kind regards,
/Anders

Hi all, Today I tried to remove the steering wheel on my 2400 coupe, but without success. I unlocked the nut and then tried to pull it off using a three armed wheel puller. But it won't move even the slightest and I'm afraid of damaging the steering wheel if I use to much force. Are there any secret...

The fuse and relay provide current for the vacuum pump for the brake servo. Normally, with the engine in operation, there is enough manifold vacuum and the pump is off thanks to a vacuum sensor (there is a small screw in the back for adjusting the cut-off, behind the rubber cap). It's there in case...

Hi, Please take a look at the attached picture, can you tell me what that fuse(?) is that I've marked with at circle? In my DIno it's replaced with a standard 10 amp fuse. I've looked at the wiring diagram but can't figure out what it is. The problem is, when I turn on the ignition, that fuse blow a...